Guralp Systems Limited
MAN-C24-0004 - CMG-CD24-R8 User's Guide

Chapter 3. Digitiser configuration

The CMG-CD24-R8 digitiser can be configured to select which data streams are transmitted at which sample rates. Parameters such as the stream identification numbers (Stream ID) can also be configured.

There are three ways to configure the digitiser:

It is recommended that either Scream or an EAM is used for configuration.

3.1 Configuration using an EAM

The CMG-EAM range of acquisition units (including the EAM-R, which was designed for use with the CD24-R8) provides a simple web interface for configuring the CD24-R8.

This process is described in detail in the “Digitiser Configuration” chapter of the CMG-EAM manual, MAN-EAM-0003, which can be downloaded from www.guralp.com/documents/MAN-EAM-0003.pdf.

3.2 Configuration using Scream

Guralp Systems' free software package Scream provides a convenient user interface for configuring the CD24-R8 digitiser. For more information about Scream, please visit www.guralp.com/scream.

Use of Scream to configure digitisers is described in the “Configuring digitisers” chapter of the Scream manual, which can be downloaded from www.guralp.com/documents/MAN-SWA-0001.pdf.

3.3 Configuration from the command line

The CD24-R8 can be configured from its own command line, which can be reached using the Terminal facility in Scream or the FORTH terminal emulator facility in the EAM's web interface. This is only recommended for advanced use and is not normally required.

Details of the CD24-R8's command-line interface are contained in MAN-CMD-0001, which is available from GSL support.