Section Index:
7.1 5Ts with high gain output option
7.2 5T high pass filter output option
Chapter 7. Connector pinouts
7.1 5Ts with high gain output option
The 5T sensor has a single connector for both power and signal output. The following details apply if the second amplification stage is being used to provide a high (10 ×) gain output channel.
This is a standard 19-pin “mil-spec” plug, conforming to MIL‑DTL‑26482 (formerly MIL‑C‑26482). A typical part-number is 02E‑14‑19P although the initial “02E” varies with manufacturer. Suitable mating connectors have part-numbers like ***‑14‑19S and are available from Amphenol, ITT Cannon and other manufacturers. |
|
Pin | Function | Pin | Function |
A | High gain +ve, N/S channel | L | Low gain –ve, vertical channel |
B | High gain –ve, N/S channel | M | Low gain +ve, vertical channel |
C | Low gain +ve, N/S channel | N | High gain –ve, vertical channel |
D | Low gain –ve, N/S channel | P | High gain +ve, vertical channel |
E | Calibration signal (all channels) | R | High gain +ve, E/W channel |
F | Power +12 V (all channels) | S | Calibration enable (all channels) |
G | Power 0 V (all channels) | T | Signal ground (essential if a long power cable is used) |
H | not connected | U | Low gain +ve, E/W channel |
J | Open/closed loop (all channels) | V | High gain –ve, E/W channel |
K | Low gain –ve, E/W channel |
| Wiring details for the compatible socket, ***‑14‑19S, as seen from the cable end. |
7.2 5T high pass filter output option
The following table applies if the second amplification stage is being used to provide a high-pass filter (with unity gain). The same connector is used and the connector information above (in Section 7.1) applies.
Pin | Function |
A | High pass filtered acceleration +ve, N/S channel |
B | High pass filtered acceleration –ve, N/S channel |
C | Acceleration +ve, N/S channel |
D | Acceleration –ve, N/S channel |
E | Calibration signal (all channels) |
F | Power +12 V (all channels) |
G | Power 0 V (all channels) |
H | Power –12 V (all channels) |
J | Open/closed loop (all channels) |
K | Acceleration –ve, E/W channel |
L | Acceleration –ve, vertical channel |
M | Acceleration +ve, vertical channel |
N | High pass filtered acceleration –ve, vertical channel |
P | High pass filtered acceleration +ve, vertical channel |
R | High pass filtered acceleration +ve, E/W channel |
S | Calibration enable (all channels) |
T | Signal ground (essential if a long power cable is used) |
U | Acceleration +ve, E/W channel |
V | High pass filtered acceleration –ve, E/W channel |